Database ” is in warm-standby state (set by executing RESTORE WITH STANDBY) and cannot be backed up until the entire load sequence is completed

 

ERROR MESAGGE:

“Database ‘<database_name>’ is in warm-standby state (set by executing RESTORE WITH STANDBY) and cannot be backed up until the entire load sequence is completed.”</database_name>

EXPLANATION:

You may encounter an error message when you back up your database.

SOLUTION:

If your database is a Secondary database, for example, in a Log Shipping scenario, or if it is a Mirror database in a Database Mirroring scenario, that is, in the “Restoring …” state, then you cannot get a backup of this database with the BACKUP DATABASE command.

You can get a backup of your database from your Primary database.

Ekrem Önsoy
Author: Ekrem Önsoy

The original article was written in Turkish by Ekrem Önsoy and translated to English by dbtut with the consent of the author. The copyright of the article belongs to the author. The author shall not be liable in any way for any defect caused by translation.

Leave a Reply

Your email address will not be published. Required fields are marked *