We can do manual failover while Fast start Failover is active. But there are some conditions. Failover or Switchover needs to be done from Primary …

We may request that Fast start Failover be disabled. We can do this disable process in 2 ways. Without using the FORCE option [crayon-6768838ad8abf032491881/] This …

The Observer stop command should be called either from the Primary Database or from the Standby Databases connected to the Primary Database. 1. We stop …

In today’s article, we will examine what are the Configurations That Cannot Be Made After Enabling Fast Start Failover. 1. Configuration Protection Mode cannot be …

In today’s article What Causes Fast Start Failover? We will look for an answer. We can see what causes this in the figure below. In …

In today’s article, we will examine Fast-Start Failover Configuration. The configuration of Fast-Start Failover consists of the following 8 steps in summary. A. Identifying the …

In today’s article, I will tell you about Fast Start Failover Data Guard – OVERVIEW. Fast-start Failover It is a fast and automatic failover operation …

In today’s article, we will learn to Failover A Physical Standby Database With SQLPLUS Commands. In a system with a Data Guard Environment consisting of …

In today’s article I will describe Resolving Insufficient SRLs Warning in Pre-Switchover Validate Command. When we run the Validate command on the Standby database that …

In today’s article we will talk about a problem about Maximum Protection Mode in DataGuard. If the Physical Standby database cannot be accessed somehow while …